Enduro EM313 Manuel De L'utilisateur page 43

Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote handset and control unit. If there is no good communication between the
control unit and remote handset, the manoeuvring system will not function and the communication icon on
remote handset is blinking.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the manoeuvring system by switching off the manoeuvring system via the isolation switch and the
remote handset for at least 15 seconds and then turn them on again.
System fails to operate, does not function at all:
Make sure that the battery power isolation switch (33) is turned on.
Check the fuse (Fig. 10) in the red positive battery cable. If the fuse is blown, it must be replaced with a fuse of
the same value (100A). Never "bridge" the fuse (if needed contact your EN ® supplier). To replace the fuse,
DURO
first disconnect the positive (+) power cable from the battery. Than release the mounting screws that hold the
fuse (Fig. 10A), replace the fuse (Fig. 10B), and finally tighten the screws securely. Close the housing of the
fuse and connect the positive (+) power cable again to the battery. The system is ready again for use.
Roller will not turn, spindle rotates freely:
The motor or gear is broken, please contact your EN ® supplier.
DURO
Rollers slip on wheels:
Check distance of rollers to tyres. You can move the rollers closer to the tyre. In certain circumstances, one of
the caravan's wheels may be moving on a surface with less traction than the other, in which case, you can
move the rollers closer to the tyre.
In case of any doubt, please call your EN ® supplier.
DURO
EN ® EM313 36
DURO
Ref: EM313-UM-TKI-0823-Rev.C.