OHAUS Pioneer PX6202M Manuel D'instruction page 28

EN-26
4. Calibration masses value will be shown in the screen.
After the display shows "Place weights" and "50.0000 g",
place weight(s) of 50 g on the pan for calibration.
5. Remove the weight(s) of 50 g from the pan. After a while,
"100.0000 g" will be displayed on the screen. Please
place weight(s) of 100 g on the pan for calibration.
6. Once the linearity calibration is completed successfully,
"Linearity done" will display.
Press any button to return to the previous screen.
5.3 Balance Setup
Enter this sub-menu to customize balance functionality.
Note: The factory default settings are shown below in bold.
5.3.1 Password
Entering the password:
The password should be a combination of 1, 2 and 3 with the maximum length of 6 digits.
Button
Numeric/Function
For example, if the user wants to set the password as "132", the following steps should be taken:
1. First press Zero / Yes, then Function / Mode, and Print / Unit at last.
2. Press Tare / Menu, and the message "Do you confirm?" will appear on the screen.
3. Press Yes or No to confirm or cancel the password input.
When the Password is set On and the password is not correctly entered, the menu settings are affected as
follows:
Calibration Menu:
Auto Calibration, InCal Adjustment, Span Calibration and Linearity Calibration are locked at the current settings.
1 / Confirm 2 / Cancel
PX Series Balance
Instructional
3 message
"Do you confirm?"