Topcom Butler 1000 Mode D'emploi page 62

Butler 1000
4.20 Changing the PIN code
Certain functions are only available if you know the PIN code of the telephone. Thanks to this
secret code, settings are displayed that only you can change. The PIN code has 4 digits. The
default PIN code setting is '0000'. If you would like to change the default PIN code and set
your own secret code, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'OLD CODE' appears on the display.
• Enter the old PIN code. Use the number keys.
• Press the Programming key
• 'NEW CODE' appears on the display.
• Enter the new PIN code in. Use the number keys.
• Press the Programming key
• 'AGAIN' appears on the display.
• Enter the new PIN code again. Use the number keys.
• Press the Programming key
• You hear a confirmation tone. The new PIN code has been set.
Caution : Do not forget your personal PIN code. If you do, you have to restore the default settings
(reset – see section 4.28).
4.21 Subscribing a handset to a Butler 1000 base unit
In order to be able to make and receive telephone calls, a new handset has to be subscribed to
the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is sub-
scribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Butler 1000 handset and base unit!!
Keep the Paging key
on the base unit begins to blink rapidly. The Line/Charge indicator
for one minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a
number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit
number. It is best to use '1' .
All manuals and user guides at all-guides.com
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'PIN CODE' appears on the display.
.
.
.
.
on the base unit pressed for 10 seconds until the Line/Charge indicator
.
repeatedly until 'BASE SUB' appears on the display.
.
63 63 63 63 63 63 63 63 63 63 63 63 63 63
will blink rapidly