Pioneer Premier DEH-P8MP Mode D'emploi page 61

Additional Information
Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears, refer to the table
below to see what the problem is and the sug-
gested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
! If no sound is emitted from the speakers,
and the error message
POWER IC DAMAGE is displayed, the bat-
tery may be dead. Have the unit serviced as
soon as possible.
! When the battery is low, the error message
Error DC/DC conv may be displayed when
you try to adjust the volume or equalizers.
Turn the source on and off and turn the
ACC on and off. If the message is still dis-
played, have the unit serviced as soon as
possible.
Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-10, 11, Electrical or me-
12, 17, 30, A0 chanical
ERROR-22, 23 The CD format
cannot be played
back
ERROR-44 All tracks are
skip tracks
Error ACC line, Leads and con-
POWER IC DA- nectors are incor-
MAGE rectly connected.
Action
Clean disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
Replace disc.
Replace disc.
Confirm once more
that all connec-
tions are correct.
Understanding error
message on rewriting the
entertainment displays
When problems occur during rewriting the en-
tertainment displays an error message may
appear on the display. If an error message ap-
pears refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. If the error cannot be cor-
rected, contact your dealer or your nearest
Pioneer Service Center.
Message Cause
CD ERROR CD player error
CD ERROR A0 Electrical error
DISC ERROR The disc does not
contain the ne-
cessary data
DOWNLOAD Writing error
ERROR,
TRANSMIT
ERROR
CD player and care
! Use only CDs that have either of the two
Compact Disc Digital Audio marks as
shown below.
Appendix
Action
Press EJECT and
check the disc.
Turn the ignition
ON and OFF.
Press EJECT and
replace the disc.
Press EJECT and
retry the rewriting.
61
En