Pioneer Premier DEH-P8MP Mode D'emploi page 16

Section
04 Tuner
Listening to the radio
1 2 3
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Band indicator
Shows which band the radio is tuned to, AM
or FM.
2 Preset number indicator
Shows which preset has been selected.
3 Stereo (ST) indicator
Shows that the frequency selected is being
broadcast in stereo.
4 LOC indicator
Shows when local seek tuning is on.
5 Frequency indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2, FM3 for FM or AM.
3 To perform manual tuning, push
Multi-Control left or right.
The frequencies move up or down step by
step.
16
En
4
5
4 To perform seek tuning, push and hold
Multi-Control left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
Multi-Control left or right.
# If you push and hold Multi-Control left or
right you can skip stations. Seek tuning starts as
soon as you release Multi-Control.