Transportation And Changing Of Installation Position; Before Calling Your After Sales Service - Whirlpool 400011209802/A Mode D'emploi

TRANSPORTATION AND CHANGING OF IN-
STALLATION POSITION

Transportation and changing of Installation position

• The original packages and foamed polystyrene (PS) can be retained if required.
• During transportation, the appliance should be secured with a wide string or a strong
rope. The instructions written on the corrugated box must be followed while transporting.
• Before transporting or changing the installation position, all the moving objects
(ie,shelves,crisper...) should be taken out or fixed with bands in order to prevent them
from getting damaged.
Carry your fridge in the upright position.
BEFORE CALLING YOUR AFTER SALES
SERVICE
If your fridge is not working properly, it may be a minor problem, therefore check the
following.
The appliance does not operate,
Check if:
• There is a power failure.
• The mains plug is not plugged in properly, or is loose.
• The thermostat setting is on position "".
• The socket is defective. To check this, plug in another appliance that you know is working
into the same socket.
The appliance performs poorly,
Check if:
• You have overloaded the appliance.
• The door is not closed properly.
• There are not enough ventilation ducts in the kitchen unit as mentioned in the installation
manual.
If there is noise:
The cooling gas which circulates in the fridge circuit may make a slight noise (bubbling
sound) even when the compressor is not running. Do not worry, this is quite normal. If you
hear different sounds, check if:
• The appliance is installed firmly as described in the installation manual.
• Objects on the appliance are vibrating.
If there is water in the lower part of the fridge,
Check if:
• The drain hole for water is not clogged (use defrost drain plug to clean the drain hole).
10