Installation And Exploitation Of The Device; Device Maintenance; Practical Suggestions - Whirlpool ADN 213 Mode D'emploi

ATTENTION!! During transport and relocation, do not tilt the device more than 45°, because this
can cause damage to the compressor.

8. INSTALLATION AND EXPLOITATION OF THE DEVICE

1. It is not allowed to switch the device on without efficient equipotential switch system!!! The
device is equipped with protective PE cord.
2. Before connecting mains to the device, check the voltage conformity between device and network
(data on rating plate).
3. Connecting the device to electrical network should be done in such a way that the plug is visible
and easily accessible for service.
4. It is inadmissible to use extensions and branch-joints!!!
5. The device should be powered from separate low-voltage circuit equipped with protective cord and
protected with fuse up to 10 A (shelves up to 16A).
6. Before commencing any maintenance or cleaning activities, switch the device off, and then remove
the plug from power outlet.
The device is started by inserting the plug into power outlet and then switching the power on. The
lighting of the switch signals the device in operation.
In low-temperature devices the door frame heater and condensate outlet heater are powered with safe
voltage 24V.
Eventual repairs of electrical installation and replacement of power cord can be done only by certified
electrician.

9. DEVICE MAINTENANCE

Before commencing any maintenance or cleaning activities, switch the device off, and then remove
the plug from power outlet!!!
All repairs and maintenance should be performed by authorized personnel only. You should
absolutely protect yourself against accidental switching the device on by unaware persons.
The interior of the device should be cleaned with wet sponge, damped with warm water and/ or neutral
detergent. Rinse and wipe dry with a soft cloth. Do not use abrasive agents. Clean external parts with soft
cloth damped with water. Do not use polishes, abrasive washing pads, stain removers or vinegar.
Clean the aggregate condenser in defined periods using brush, duster or compressed air.

10. PRACTICAL SUGGESTIONS

If refrigeration device is not working properly, before calling service check the occurrence of the
situations described below:
refrigeration device is not working
is the mains cord plugged into power outlet?
is the outlet powered (is the fuse not blown)?
the temperature in device has risen rapidly (signaled with alarm on thermal regulator
display)
has the device door been opened often recently?
is the device not overloaded with products or does the placement of products not hamper the air
circulation inside the device?
has the device not been loaded with hot, not cooled products?
is the device clearance from walls similar to the one given in instruction?
24