Installation And Operating Conditions Of The Appliance; Preparing The Appliance For Operation - Whirlpool ADN203 C Mode D'emploi

DESCRIPTION OF THE APPLIANCE, BASIC PARTS
See fig. 1, page 1
1 Advertising panel
2 Thermostat knob
3 Interior lighting on/off button
4 Advertising panel light on/of button
5 LED lighting
1 - THERMOSTAT DIAL. The temperature is indicated on the thermostat dial. Turning
the thermostat dial clockwise reduces the temperature in the chamber.
The fan for the appliance is activated and operates continuously.
2 - INTERIOR LIGHTING ON/OFF BUTTON. The interior lighting is switched on/off by
pressing this button. Symbol "|": on; "O": off.
3 - ADVERTISING PANEL LIGHT ON/OFF BUTTON. The advertising panel lighting is
switched on/off by pressing this button. Symbol "|": on; "O": off.
INSTALLATION AND OPERATING CONDITIONS OF THE

Preparing the appliance for operation

It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
•
Therefore take out adhesive tapes from sides and simply lift the appliance up and
•
take out the board. Strip adhesive tapes off and open the door. Remove the spacer
above the door.
When positioning the appliance in chosen location, it will move more easily into
•
position if you lift the front a little and incline it backward allowing it to roll on its
casters. If your appliance is fit with screwed handles. Do not rise or push it
taking by handles.
If the appliance is brought in from the cold (temperature is not higher than +12
°C), you should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and
transport materials aren't removed. Suitably dispose the packaging material.
Positioning
Place the appliance in a dry, well ventilated room
•
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
APPLIANCE
6
6 Fan
7 Shelves
8 Condenser
9 Thaw water drip tray
10 Compressor