Installation And Operating Conditions Of The Appliance; Preparing The Appliance For Operation; Temperature Regulation - Whirlpool ADN203 C Mode D'emploi

INSTALLATION AND OPERATING CONDITIONS OF THE

Preparing the appliance for operation

It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
•
Therefore take out adhesive tapes from sides and simply lift the appliance up and
•
take out the board. Strip adhesive tapes off and open the door. Remove the spacer
above the door.
When positioning the appliance in chosen location, it will move more easily into
•
position if you lift the front a little and incline it backward allowing it to roll on its
casters. When placing, moving, lifting the appliance, do not hold the door
handles, do not pull the condenser at the rear part of the refrigerator and
do not touch the compressor unit.
If the appliance is brought in from the cold (temperature is not higher than +12
°C), you should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and
transport materials aren't removed. Suitably dispose the packaging material.
Positioning
Place the appliance in a dry, well ventilated room.
•
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
Do not cover the ventilation holes at the top of the appliance – it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between
the top of the appliance body and any furniture that may be above it. If this
requirement is not followed, the appliance consumes more electrical energy and its
compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm must be left between the
•
appliance body and the wall. Overall dimensions for installation of the
refrigerator - see page 1, fig. 2.
The appliance must stand on a level surface and must not touch the wall.
•
necessary, regulate the height of the appliance by adjusting the levelling feet: by
turning them clockwise – the front of the appliance rises, by turning them counter
clockwise – it comes down. If the appliance is tilted slightly backward – the doors will
close by themselves
The temperature in the refrigerator compartment is controlled using the thermostat
knob 2 (see page 1, fig. 1) by turning it to one side or the other. The temperature
indication in digits is shown beside the thermostat knob.
APPLIANCE
.

TEMPERATURE REGULATION

7
If