Whirlpool 400011209802/A Mode D'emploi page 18

20. Remove the door hang rails
ts to the holes on the appliance door by leaving the necessary space using unit door
(12)
spacer
. (fig.N)
(11)
21. Open the appliance door. Place the unit door
ment bolts(12) into the slots on the door hang
22. Place the washers
23. 1~2 mm gap between the unit itself and unit door is vital for appliance performance.
Close the door and make the accurate adjustment of the unit door
screwing the adjustment bolts
the door hang
for other directions. (fig.P1)
(2)
24. Place the door bottom fixings
pliance door and unit door
th screws
. (fig.O)
(6)
25. Screw the door bottom fixings
26. For the adjustment of the space between the unit upper door
can unscrew the screws
and unit upper door
gback the screws
27. Slide the hang cover
from the appliance door. Screw the adjustment bol-
(10)
and screw the nuts
(13)
for vertical adjustment and by the help of the slotson
(12)
to the bottom of the appliance door between theap-
(5)
. Screw the door bottom fixings
(15)
to the unit door
(5)
then adjust the space between the appliance upper door
(6)
by the spring effect of the door bottom fixings
(15)
.
(6)
onto the door hang
(3)
onto the appliance door insertingadjust-
(15)
. (fig.N)
(2)
onto the adjustment bolts
(14)
by screws
(15)
(15)
. (fig.P2)
(2)
18
. (fig.N)
(12)
by screwing orun-
(15)
to the appliance doorwi-
(5)
. (fig.O)
(7)
and the unit itself, you-
while screwin-
(5)
(19)