Télécharger Imprimer la page

LA NORDICA CARILLON 4:3 Instructions Pour L'installation, L'utilisation Et L'entretien page 17

Publicité

Les langues disponibles

Les langues disponibles

CARILLON 4:3 – CARILLON 16:9 – CARILLON CLASSIC
2.
TECHNICAL DESCRIPTION
The chimney stoves of La Nordica are suitable to heat living spaces for some periods. As fuel, wood logs are used.
The stove is made of sheets in galvanized and painted steel, of cast iron (grate and grate holder of the hearth,
exhaust pipe) of majolica tiles and of glass panels. The hearth is totally sheathed with cast-iron single sheets and
refractory material
(IRONKER). Inside there are a easy extractable thick flat grate and its holder. The combustion
chamber is hermetic welded and is sheathed with a painted steel carter.
The inside smoke plate made of vermiculite, reflects the fire radiation and increases the internal temperature of the
combustion chamber. This process together with the exhaust gases flows, makes optimal the combustion and
improves the efficiency.
Singular feature of the model "Carillon" is the pivoting body, i.e. the
possibility of rotating the stove of +- 45° (with r egard to its base axis)
also when is lighted. It is also possible to block the appliance at the
wished position by a knob. (Picture 1 pos.A)
The one-piece ceramic glass of the door (resistant up to 700 ° C)
allows a wonderful view on the burning flames. Furthermore, it is thus
avoided the output of sparks and smoke.
Below the hearth grate there is an extractable ash drawer, (Picture 9
pos. A).
The heating of the environment is made by irradiation: through the
panoramic glass and the external hot surfaces of the stove, the heat
is radiated into the environment.
The stove is equipped with controls of primary and secondary air by
which it is adjusted the combustion air.
1A - Primary air register (left lever)
Below the hearth door, on the front left side, there is the primary
air register, in the style of lever (Picture 2 - 1A)
With this air register, it is adjusted the passage of primary air into
the low part of the stove and through particular channels flows in
the fuel direction. The primary air is necessary for the combustion
process during lighting. The ash drawer must be regularly
emptied, so that the ash does not obstruct the entry of the
primary air for the combustion.
In order to open the air flow, the bar must be completely pulled
out,
During wood combustion, the register of primary air must be
opened only for a while, because otherwise the wood burns too
fast and the stove may overheat.
(see paragraph 10).
2A - Secondary air register (right lever)
Below the hearth door, on the right front side there is the
secondary air register (Picture 2 - 2A).
The secondary air, passing through the two lateral jambs of the
front side, heats itself starting the double combustion and keeping at the same time the glass clean ( with open
register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 2 - 2A).
3.
RULES FOR INSTALLATION
The stove, assembled and ready for the installation, must be connected with a junction to the existing flue of the
house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections must be
tight. It is obligatory to respect the National and European rules, local regulations concerning building matter
and also fireproof rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention to
windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for the
connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped with a wall
connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your floor can support the weight of the stove (for ex. distributing weight plate).
Please do not install the stove in a inclined level in order to avoid tensions during the rotation.
LA NORDICA is not responsible in case of modification of the product and for the use of not original spare
parts. The hearths must not be modified. THE HEARTHS MUST NOT BE MODIFIED.
7196755 – EN
Picture 1
1A
2A
A
Picture 2
17

Publicité

loading