Sony HT-NT3 Mode D'emploi page 42

press RX/TX
control, [Bluetooth Mode] is
switched to [Receiver] and the
selected input appears in the front
panel display (page 25).
Picture
There is no picture or the picture is not
output correctly.
 Select the appropriate input
(page 9).
 While holding INPUT, press VOL +,
VOL – and VOL + in sequence to
reset the video output resolution to
the lowest resolution.
There is no picture when you make an
HDMI cable connection.
 If you connect a device supporting
HDCP2.2, be sure to connect the
device to the HDMI IN 1 jack and the
TV to the HDMI OUT (ARC) jack of
the system.
 The system is connected to an input
device that is not HDCP (High-
bandwidth Digital Content
Protection) compliant. In this case,
check the specifications of the
connected device.
 Disconnect the HDMI cable, then
connect it again. Make sure that the
cable is firmly inserted.
3D content from the HDMI IN 1/2/3 jack
do not appear on the TV screen.
 Depending on the TV or video
device, 3D content may not appear.
Check the supported HDMI video
format (page 55).
4K content from the HDMI IN 1/2/3 jack
do not appear on the TV screen.
 Depending on the TV or the video
device, 4K content may not appear.
Check the video capability and
settings of your TV and video
device.
 Use a High Speed HDMI Cable with
Ethernet.
42
US
on the remote
No image is output from the TV when
the system is in standby mode.
 When the system enters standby
mode, the image from the last
selected HDMI device before you
turned off the system is displayed. If
you are enjoying content from
another device, play the content on
the device and perform the One-
Touch Play operation, or turn on the
system to select the HDMI device
from which you want to enjoy
content.
 Set [Standby Through] to [On] in
[HDMI Settings] (page 26).
An image is not displayed on the entire
TV screen.
 Check the setting of [TV Type] in
[Screen Settings] (page 23).
 The aspect ratio on the media is
fixed.
Color irregularity occurs on the TV
screen.
 If the color irregularity persists, turn
off the TV set once, then turn it on
after 15 to 30 minutes.
 Make sure that no magnetic object
(magnetic latch on a TV stand,
health care device, toy, etc.) is
placed near the system.
Images from the HDMI jack is distorted.
 Video from the device connected to
the HDMI jack may be distorted. If
this happens, set [Video Direct] to
[On] (page 24).
Sound
No sound or only a very low-level
sound of the device connected to the
system is heard.

 Press
+ and check the volume
level (page 51).

 Press  or
muting function (page 51).
+ to cancel the