Electrical Connection - Mac allister MPTP1500B MAC Notice Originale

MPTP1500B MAC
GB
The electric motor installed is completely wired ready for operation.
The connection meets the requirements of the German standards VDE and
DIN.
The connection to the electric power supply to be effected by the customer as
well as the extension cable must also meet these requirements.
Connection and repair work on the electrical installation may be carried out by
a qualified electrician only.
Damaged electrical connection cables
Insulation damage often occurs on electrical connection cables.
Reasons are:
• Pressure, if the connection cable is drawn through windows or doors.
• Kinks due to improper fixing or drawing of the connection cable.
• Cuts due to running over the connection cable.
• Insulation damage due to pulling out of the mains socket.
• Ruptures due to aging of the insulation.
Such damaged electrical connection cables must not be used and are a dan-
ger to life due to their insulation damage.
Check electrical connection cables regularly for such damage. Make sure that
the connection cable is not live when checking.
Electrical connection cables must comply with the applicable VDE and DIN
regulations. Only use connection cables with the label H 07 RN.
A label on the connection cable indicating the type is stipulated.
• The product meets the requirements of EN 61000-3-11 and is subject to
special connection conditions. This means that use of the product at any
freely selectable connection point is not allowed.
• Given unfavorable conditions in the power supply the product can cause
the voltage to fluctuate temporarily.
• The product is intended solely for use at connection points that
a) do not exceed a maximum permitted supply impedance "Z", or
b) have a continuous current-carrying capacity of the mains of at least 100
A per phase.
36

Electrical connection

Electrical connection