Mac allister MPTP1500B MAC Notice Originale page 31

MPTP1500B MAC
Connecting the dust extractor for thicknessing (Fig. 9)
• Remove the ripping fence.
• Push the cutter block guard back and fix the suction connector.
• The suction connector is fitted in such a way that both switching pins are in
line with the mortises. Then push the switching pins into the mortises.
For an optimum dust extraction, the air flow rate must be 20 m/s at a minimum.
Cutter block guard (Fig. 10.1/10.2)
Height adjustment is done with the star grip J screw fitted to the left side of
the machine. After releasing the star grip screw K, the cutter block guard can
be moved to the side and the correct planing width set. Press the guard down
again to fix it in the right position, and tighten the handles.
Fig. 10.1
K
J
Surfacing:
The amount of chip removal is set by means L of the scale M on the front side
of the table top M. The best surface is obtained at a planing depth between 0.5
and 1.5 mm.
Fig. 9
Fig. 10.2
K
J
Operation
M
O N
L
GB
31