Mac allister MPTP1500B MAC Notice Originale page 17

MPTP1500B MAC
General Safety
10. Connect dust extraction equipment
If the tool is provided for the connection of dust extraction and collecting
–
equipment, ensure these are connected and properly used.
11. Do not abuse the cord
Never yank the cord to disconnect it from the socket. Keep the cord away
–
from heat, oil and sharp edges.
12. Secure work
Where possible use clamps or a vice to hold the work. It is safer than
–
using your hand.
13. Do not overreach
Keep proper footing and balance at all times.
–
14. Maintain tools with care
Keep cutting tools sharp and clean for better and safer performance.
–
Follow instruction for lubricating and changing accessories.
–
Inspect tool cords periodically and if damaged have them repaired by
–
an authorized service facility.
Inspect extension cords periodically and replace if damaged.
–
Keep handles dryclean and free from oil and grease.
–
15. Disconnect tools
When not in use, before servicing and when changing accessories such
–
as blades, bits and cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are
–
removed from the tool before turning it on.
Avoid unintentional starting
–
17. Ensure switch is in "off" position when plugging in.
18. Use outdoor extension leads
When the tool is used outdoors, use only extension cords intended for
–
outdoor use and so marked.
19. Stay alert
Watch what you are doing, use common sense and do not operate the
–
tool when you are tired.
20. Check damaged parts
Before further use of tool, it should be carefully checked to determine
–
that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage
–
of parts, mounting and any other conditions that may affect its operation.
Safety
GB
17