Before You Start; Your Product - Mac allister MPTP1500B MAC Notice Originale

MPTP1500B MAC
GB
Things to check before you start





Your product

To assemble your product, consult the assembly
guide located at page 20 of the guidebook
12
Check all parts for possible transport damage after un-
packing. The supplier must be informed immediately in
case of complaints. Later complaints are not accepted.
Check the delivery for completeness.
Familiarise yourself with the device before using it by
consulting the operating instructions.
Before commissioning, be aware of the safety notices.
All protective and auxiliary equipment, especially the
guard must be attached.
Carry out work such as re-tooling, adjusting, measuring
and cleaning only when the motor is switched off.
Disconnect the mains plug!
1. On/Off switch
2. Hand crank
3. Chip extractor
4. Parallel stop
5. Clamping lever
6. Setting knob for the chip depth
7. Planing knife cover
8. Feed table
9. Planing table

Before you start