Maintenance - Mac allister MPTP1500B MAC Notice Originale

MPTP1500B MAC
GB

Maintenance

The golden rules of care
1. Keep the instructions near the machine.
2. Keep the machine clean.
3. Wear protective goggles when cleaning the
machine.
4. Inspect the product before each use for worn
and damaged parts. Do not operate it if you
find broken or worn parts.
Machine care
The planer/thicknesser requires little maintenance. The ball bearings are
permanently lubricated. After approx. ten operating hours, lubrication of the
following parts is re commended:
• Bearing of the infeed and output roller
• Bearing of pulley and sprocket
The threaded spindle for height-adjustment of the thicknessing table may
only be treated with a dry lubricant agent.
The table surfaces as well as the infeed and output rollers must always be
kept free from resin.
Regularly clean infeed and output rollers.
In order to avoid overheating of the motor, regularly check the air openings
for any dust sticking on.
After a longer period of use, it is recommended to have the machine checked
by an authorized dealer service.
34
WARNING!
Switch the machine off and disconnect it
from the mains voltage before carrying out
any maintenance and adjustment works.
Maintenance