Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Machine Set Up
!
!
Always ensure that the machine is switched off before making any adjustments
Raise / Lower the Floor-tool
7
8
9
To lower the floor-tool move the floor-tool lever into the upper position (Fig.7).
To raise the floor-tool move the floor-tool lever into the lower position (Fig.8).
Note: The machine will not operate in reverse with the Floor-tool lowered.
Note: The floor-tool lever guide is designed to be reversible and replaceable.
Fitting the Floor-tool
10
11
12
13
Lower the floor-tool arm by moving the floor-tool lever to the upper position (See above).
Loosen the retaining knobs on the floor-tool and slide onto the holding bracket (Fig.10).
Tighten the retaining knobs to finger tight. (Fig.11).
Push waste collection pipe onto the floor-tool; ensure a tight fit (Fig.12).
Note: Raise floor-tool again before driving to the cleaning area (See Above).
Breakaway Floor-tool
The floor-tool design incorporates a safety knock-off feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction during
forward movement (Fig.13).
Make sure you do not over tighten the retaining knobs to ensure correct operation.
8
Publicité
Table des Matières
