Machine Set-Up; Tilting The Handle; Fitting The Top Tank; Fitting The Brush - Nacecare TT 1117/100 Mode D'emploi

!
Please read before commencing any operation.
After the removal of all the packaging, carefully open and check the contents.

Tilting the handle

Fig 1
Fitting top tank
Fig 3

Fitting the brush

Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
The Pad is retained using Numatic's own PadLoc system. (Ask your supplier for details)
Only use manufacturer supplied brushes / pads.
TT 1117 requires a 17" brush or pad.
TT 1120 requires a 17" brush or pad
Safety gloves are recommended for the changing of used brushes.
Machine Set Up
Using the handle position lever
(fig 1).
Move the handle into the upright
position (fig 2).
Fit the top tank to the machine
(fig 3).
Fit both the vacuum hose and the
floor tool hose to the separator
(fig 4).
Fit the brush /pad to the drive chuck,
twist to lock the brush
(Fig 5) / pad in place (Fig 6).
Fig 5
Fig 2
7
!
Fig 4
Fig 6