Brush Pressure; Emergency Stop Button And Horn; Anti-Tip System - Nacecare Numatic iINTERNATIONAL TTB 2120/100T Mode D'emploi

28
Note: The run-time of the machine may decrease if the load on the brushes is increased
The TTB 2120 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop button and the machine will
be disabled. To reset, turn emergency stop button clockwise (Fig.29).
After resetting the emergency stop button, to restart the machine,
turn the ignition key to the 'Off' then the 'On' position again.
30
!
Care must be taken to reduce speed when cornering or manoeuvring
31
The buffers are designed to be replaceable
when worn.
The machine is equipped with a brush-pressure load warning system
(Fig.28). As the load on the Brush increases the LEDs on the Load
Indicator will illuminate from left to right.
The horn is located on the right-hand side of the operator control panel
(Fig.30).
The TTB 2120 is equipped with an Anti-tip system. If the operator
attempts to turn a corner when the machine is going at speed,
the machine will automatically slow down preventing the machine from
tipping over. Additionally the buffers at the front of the machine are
designed to prevent the machine tipping in the event of the operator
turning sharply (Fig.31).
Machine Operation

Emergency Stop Button and Horn

12

Brush Pressure

29

Anti-tip System

!