Filling The Clean-Water Tank; Fill Level Indicator - Nacecare Numatic iINTERNATIONAL TTB 2120/100T Mode D'emploi

!
Always ensure that the machine is switched off before making any adjustments
The TTB 2120 is equipped with a large capacity (21 US Gall) clean water tank, allowing for large
areas to be covered in a single fill.
22
To fill the clean water tank extend the Flexifill hose, remove the rubber seal and fill from a suitable
water outlet (Fig.22). Replace seal and hose to original position when finished.
Alternatively unscrew the filler cap completely (Fig.23) and fill the tank using a hose or preferred
method (Fig.24).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not
allowed to enter the Clean water tank during the filling process. If using a bucket or similar,
ensure it is always clean and free from debris.
25
Full
When filling the clean water tank, do not fill above the clean water tank emptying hose retaining
clip (Fig.25). This can be found at the rear of the machine.
!
If you need to access the batteries, make sure that the waste water tank is
Filling the Clean Water Tank
23
empty before lifting.
10
Machine Set Up
24

Fill Level Indicator

!
!