Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
!
Do not operate machine unless the operator manual has been read and fully understood.
The machine is now ready to be driven to the cleaning site (see the quick set-up guide if
necessary).
Before performing the cleaning operation, place out appropriate warning signs and sweep or
dust-mop the floor.
When you have arrived at the cleaning site, lower the Floor-tool (see page 8) and the brush
deck (see page 9).
26
!
Important
27
The vac shut off system fitted to your machine
stops the airflow when the top tank is full!
It does not shut the power off to the vac motor,
the vac motor will continue to run, but there is an
audible difference in the sound when the shut off
system operates.
See Page 16 for more details on checking and
cleaning the shut off system.
Always ensure that the floor is pre-swept and
relevant safety signs are displayed.
Machine Operation
Setting the Cleaning Controls
Insert the key into the on / off switch and
quarter-turn it clockwise to the 'ON' (1) position
(Fig.26).
The battery charge-level indicator will illuminate
(Fig.27).
Set the water flow rate as required, depending
on floor type and level of soiling.
= No Flow
= 0.13 gpm
= 0.26 gpm
= 0.39 gpm
= 0.52 gpm
= 0.79 gpm
Waste Water Tank Full
11
!
!
Publicité
Table des Matières
