SodaStream GAIA Mode D'emploi page 14

SET UP
SODASTREAM
Please note that the
SodaStream GAIA is
TM
compatible with the
SodaStream CO Quick
®
2
Connect Cylinder and is
NOT compatible with
the SodaStream Screw
®
System Cylinder.
INSTALLING THE CO
QUICK CONNECT CYLINDER
1. Place the SodaStream GAIA
Water Maker on a flat sturdy surface and
pull open the back cover.
2. Remove seal and cap from the
SodaStream CO Quick Connect Cylinder.
®
2
WARNING! Never insert or replace the
CO Quick Connect Cylinder while a
2
plastic carbonating bottle is installed in
the Sparkling Water Maker. This can
cause the Carbonating Bottle to burst.
3. Raise the cylinder handle. Insert the
CO Quick Connect Cylinder in the back
2
of the Sparkling Water Maker.
4. Lower the Cylinder Handle.
5. Reinstall the back cover. Now you are
ready to create the bubbles.
14
CO QUICK CONNECT CYLINDER
®/MD
2
COMPATIBLE SODASTREAM
CO QUICK CONNECT CYLINDER
2
2
Sparkling
TM
NON COMPATIBLE
CO SCREW SYSTEM CYLINDER
2
1
3
4
2
Bottom
first
5