Danfoss CF-MC Instruction page 4

Masquer les pouces Voir aussi pour CF-MC:

Les langues disponibles

Instruction CF-MC Master Controller

1. When?

• If the Master Controller in an existing CF2-system is reset to factory

settings or replaced with another Master Controller, it is necessary to

reset all the other CF2-system components also, in order to be able to

re-install them to the reset or replaced Master Controller, CF-MC !

2. How?

Note: The Master Controller should only be "Reset" to factory settings if the

normal in- and uninstallation procedures can not be followed!

2.1 Resetting the Master Controller, CF-MC - g. 1:

• Disconnect the 230V power supply to the Master Controller until the

power LED

• Press and hold at the same time the menu selection button

OK button

• Reconnect the 230V power supply to the Master Controller and

release the three buttons when the power LED

LEDs

• The Master Controller is reset when all output LEDs

VI.UN.A1.52

is OFF

, and the output selection button

are ON

Produced by Danfoss Floor Heating Hydronics 09.2005

, the

and all the output

then goes OFF