Danfoss CF-MC Instruction page 5

Instruction CF-MC Master Controller Instruction CF-MC Master Controller
2.2 Resetting the Room Thermostats, CF-RS, -RP, -RD and -RF – g 2:
• Remove the Room Thermostat from the back plate
one of the batteries
• Press and hold the push button
battery
• Release the push button
again
• The Room Thermostat is now Reset and ready for installation to a
Master Controller, CF-MC
2.3 Resetting the Remote Controller, CF-RC – g 3:
• At the same time, activate the Soft key 1
down selector
• The Remote Controller requests con rmation before resetting.
Con rmation with "yes" Resets the Remote Controller
• By con rming Reset with "yes" the Remote Controller is now ready for
installation to a Master Controller, CF-MC
2.4 Resetting the Repeater Unit, CF-RU – g 4:
• Disconnect the Repeater Unit from the 230V power supply
• Press and hold the push button
power supply
• Release the push button
again
• The Repeater Unit is now Reset and ready for installation to a
Master Controller, CF-MC
VI.UN.A1.52
(Link test) and reconnect the
when the red LED
(Link test) and reconnect the 230V
when the red LED
Produced by Danfoss Floor Heating Hydronics 09.2005
and disconnect
has been On and O
, the soft key 2
has been On and O
and the
5 5