Philips SUP025PY Mode D'emploi page 29

will start to come out of the spout (Fig.01,
pos.13).
The coffee will stop flowing automatically when
the preset level is reached (see par.7.3). You
can interrupt the flow of coffee by pressing
the button (Fig.01, pos.23 or 24).
7.2 Making coffee with ground coffee
In this operating mode, you must use
the supplied measuring spoon
(Fig.01, pos.21) to dose the ground coffee.
Only use ground coffee suitable for
espresso coffee makers in the doser
(5); placing coffee beans, instant coffee and
other materials inside the doser causes
damage to the appliance.
Keep fingers away from the ground
coffee doser since there are moving
parts.
Use the supplied measuring spoon (21) to
measure the right quantity of ground coffee to
place in the doser.
Use only one filled measuring spoon at a time;
to make two coffees, you must go through the
entire process twice.
• Press the button (22) to select the function;
the LED lights up.
• Lift the cover of the ground coffee doser
(Fig.13).
• Fill the measuring spoon with one coffee dose;
discard any excess quantity of ground coffee.
• Fill the doser with the ground coffee (Fig.14)
• Close the cover of the ground coffee
doser.
• To make the coffee, press the desired coffee
button (23) or (24); the selected button starts
flashing (see chapter 15), while the other
switches off.
• The dispensing cycle begins.
• After carrying out the prebrewing cycle, coffee
will start to come out of the spout (13).
• The coffee will stop flowing automatically when
the preset level is reached (see par. 7.3).
You can interrupt the flow of coffee by pressing
the button (23) or (24).
• Then the machine automatically returns to the
normal operating mode (see para. 7.1).
7.3 Adjusting the quantity of coffee per
cup
Your coffee maker has been programmed to
make 2 types of coffee: espresso coffee with the
button (23) and weak coffee with the button (24).
To adjust the programmed values to the size of
your cups, place the cup under the coffee
dispenser (13), press the button of the desired
type of coffee (23) or (24) and keep it pressed.
Wait for the machine to fill the cup up to the
desired level and, then, release the button.
Note: keep the button (23) or (24)
pressed during the entire coffee
dispensing process.
In this way, the appliance is programmed to
supply the quantity of coffee you selected.
8 MAKING HOT WATER
Caution: splashing may occur at the
start – scalding hazard! The hot water
nozzle and pipe can reach high temperatures:
avoid touching directly with your hands.
• Before dispensing hot water, make sure that
the green temperature-ready LEDs (23 and
24) emit a fixed light.
Proceed as follows when the appliance is ready
to dispense hot water:
• Place a cup and/or pitcher under the steam/
hot water nozzle (Fig.15).
• Turn the knob anticlockwise as shown in Fig.15.
• When you have obtained the desired quantity
of hot water, turn the knob clockwise to shut
off the flow. The appliance resets itself so that
it is ready for normal operation.
9 MAKING STEAM / PREPARING
CAPPUCCINO
Steam can be used to froth the milk
for cappuccinos but also to heat
beverages.
Scalding hazard!
Splashing may occur at the start –
scalding hazard! The hot water nozzle and
pipe can reach high temperatures: avoid
• 29 •
ENGLISH