Philips SUP025PY Mode D'emploi page 27

4 INSTALLING THE COFFEE
MAKER
For your safety and the safety of third
parties, follow the "Safety Standards" (see
chapter 3).
4.1 Packaging
The original packaging was designed and made
to protect the appliance during shipment.
We recommend you keep it for future needs.
4.2 Preliminaries
• Remove the coffee maker from the
packaging and position it in a suitable
location that meets the requirements
specified and described in the safety
standards (chap.3).
• Open the machine door, take the drip tray
(12) from the package, and fit the dregs box
(10); then, fit the drip tray in the machine
(Fig.21).
• Make sure that the drip tray and plate
(Fig.01, pos. 12), the coffee grounds drawer
(10) and the coffee dispenser (17) are fitted
correctly and that the front cover (15) is
closed.
• Keep the cleaning brush (20) and the key of
the coffee dispenser (19) handy, which were
supplied with the appliance.
If the red light (29) is still on when the machine
is started, it means that one of the parts
described above is positioned incorrectly.
Caution: You must read chapter 15.
This chapter explains in detail the
meaning of all the visual signals displayed
to the user through the lights (LEDs) found
on the control panel.
4.3 Preparing the coffee maker for use
• Open the water tank cover (Fig.02) and
remove the tank (Fig.03). Rinse and fill with
fresh potable water (Fig.04); we recommend
that you do not exceed the "MAX" level mark.
Replace the water tank in its housing and
reposition the cover on top.
Always fill the tank (9) with fresh still
water. Hot water and other liquids can
damage the tank and/or the appliance. Do
not operate the appliance without water:
make sure that there is enough water inside
the tank.
• Lift the cover (Fig.05) and fill the container
with coffee beans (Fig.06).
Use coffee beans only. Ground and
instant coffee, as well as other items,
cause damage to the appliance.
• Close the cover of the coffee bean container
(1).
• Insert the plug into the outlet at the back of
the coffee maker (Fig.07) after making sure
that the ON/OFF switch (7) is in the "O"
position.
• Insert the other end of the plug into a suitable
wall outlet.
• When not in use, the ON/OFF switch of the
appliance is in the "O" position. To switch ON
the coffee maker, simply press the switch
(Fig.08). The LEDs (23) and (24) start flashing
on the control panel.
• To fill the circuit, direct the steam/hot water
nozzle (Fig.01, item 14) towards the drip tray,
place a cup or suitable vessel under the steam
nozzle and turn the knob anticlockwise
(Fig.09). Wait for water to flow regularly from
the nozzle and, then, shut off the flow by
turning the knob clockwise.
Note: You must fill the circuit of the
appliance if the machine is switched
ON for the first time, the machine has not
been used for a long time, the water tank
has been emptied completely or the warning
light (27) flashes.
• After switching ON the appliance, LEDs (23)
and (24) flash simultaneously during the
heating phase. Once the heating phase is
finished, LEDs (23) and (24) emit a fixed light.
• At this point, your coffee maker is ready for use.
• Follow the instructions below to dispense
coffee, hot water or steam and use the
appliance correctly.
• 27 •
ENGLISH