Troubleshooting - Trotec DH 150 Mode D'emploi

• Fan speed switch . This switch can be used to de-
cide whether the relative humidity control switches
the fan on or off with the compressor or whether it
is allowed to run permanently . Air circulation is
greatly improved when the fan runs permanently .
This results in less condensation water because
areas of air are prevented from standing still .
• The adjustable air temperature control on the inside
of the heating attachment has to be set to the lo-
west temperature when the optional rotating heating
attachment has been attached .
• Connect the RCU control in the dehumidifier with
the help of the supplied cable to the terminal board
on the inside of the RCU unit . Thread the cable
through the duct seal or the cable duct opening at
the base of the unit and use the strain relief clamps .

04. trOuBleshOOtInG

m
Disconnect the unit from the mains power
supply before you remove any cover pa-
nels or before you climb into the machine.
Before you decide to contact our Product Support
Department, please have a qualified electrician check
your unit according to the following check list . Do not
change any of the internal control settings . They are
factory set and sealed . If you need any help or are
unsure about anything regarding your product, please
contact our Customer Support Team:
Tel.: +49 2452 969 - 400
E-mail: info@trotec .de .
EN
·
Fax: +49 2452 962 - 200
Operating manual – DH 150 / 300 / 600
B - 4