Publicité
BMW 7 E65 + E66 + E67
03/05 – 12/08
Ref. 1553T60
Fitting instructions
1)
Disassemble the bumper in the rear and permanently remove the buffer beam. (Attention : keep the
plastic part of the buffer beam).
2)
Place the tow bar with points (A) against the back plate of the vehicle on the provided bolts where the
buffer beam was fixed. Insert washers and nuts and tighten everything firmly (see tension).
3)
Make an incision in the bottom of the bumper according to picture 1. Place the delivered nuts on points
(C) of the tow bar. Place the plastic buffer beam on points (B) of the tow bar. Assemble the bumper on
the vehicle. Fix the screws on points (C) of the tow bar behind the black plastic styling strip.
4)
Assemble the ball on the tow bar together with the socket plate holder (P36).
Disassemblage of the bumper
- 2x3 screws in the wheel cases
- 4 screws behind the black styling strip (at the back of the bumper)
- 2x1 screw under the rear-lights, behind the plastic cap in the same color as the coach work
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
Publicité
