Publicité
Les langues disponibles
Les langues disponibles
Problem
The grass is not cut into mulch.
The grass is cut irregularly.
The drive system does not oper-
ate correctly
Transportation and storage
•
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
•
Always use approved containers for storage and
transportation of fuel.
•
Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
•
Safely attach the product during transportation to
prevent damage and accidents.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the product in a dry and frost free area.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
18
Possible cause
The grass is wet.
The grass is too high.
One or more of the blades are
not sufficiently sharp.
The wheels are not in correct po-
sition.
One or more of the blades are
not sufficiently sharp.
The drive belt is not sufficiently
tight or there is dirt on the pulleys
or drive belt.
Transportation, storage and disposal
Solution
Do not operate the product when the grass is
wet. Wait until the grass is dry.
Cut first with the cutting height set high. Low-
er the cutting height and cut again.
Cut only ½ of the cutting width at a time.
Sharpen or replace the blades.
Set the cutting height at the same level for all
4 wheels.
Sharpen or replace the blades.
Let an approved service agent do mainte-
nance on the drive system.
1241 - 001 - 08.07.2019
Publicité
