Publicité
Les langues disponibles
Les langues disponibles
Check that the voltage stated on the device's information plate matches the voltage used in your region.
TURNING THE VACUUM CLEANER ON
1. Place the vacuum cleaner on a dry and level floor.
2. Pull out the cord by the plug and insert the plug into a power socket.
3. Turn the vacuum cleaner on by pressing the on/off foot pedal
4. Depending on the type of floor you want to vacuum, you can adjust the floor nozzle.
For cleaning hard floors, make sure the brushes in the floor nozzle are down.
For cleaning carpeting or a carpet, make sure that the brushes in the floor nozzle are retracted.
When it is hard to move the brush over the surface you can decrease the suction power with the button to set the suction
power min - max or open the the additional suction power control on the handle of the hose.
TURNING THE VACUUM CLEANER OFF
1. Turn the vacuum cleaner off by pressing the on/off foot pedal
2. Unplug the vacuum cleaner, hold the plug and automatically rewind the cord by pressing the cord rewinding foot pedal
. Guide the cord with your hand to prevent possible damage. The power cord will be drawn in the vacuum cleaner.
Check the hose, dust collector and filters regularly to prevent any problems. If the hose is clogged, empty it. Empty the dust
collector when it is full and clean or replace the filters when they are dirty.
EMPTYING THE DUST COLLECTOR
On the dust collector you will find a maximum indication max fill [17]. Empty the dust collector when the amount of dirt
reaches the maximum indication.
1. Grab the handle of the dust collector and press the button [4] to release the dust collector. Lift the
dust collector.
2. Hold the handle of the dust collector while holding it above a dust bin. Press the button [18] to
open the bottom of the dust collector. The bottom lid opens automatically and releases the dirt in
the dust bin.
3. To fully empty the dust collector, calmly shake it above the dust bin.
4. Close the bottom lid of the dust collector. You will hear a click when the bottom lid is closed
correctly.
5. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed correctly.
CLEANING THE CYCLONE FILTER
The filters play an important part in the efficiency of the vacuum cleaner. When the filters are clogged the performance will
decrease. Therefore cleaning or replacing the filters frequently is essential. Clean the cyclone filter every six months.
1. Grab the handle of the dust collector and press the button [4] to release the dust collector. Lift the
dust collector.
2. Pull the clip [19] forwards and open the lid of the dust collector.
3. Pull the cyclone filter [20] out of the lid of the dust collector.
4. Clean the cyclone filter [20] under lukewarm water. Do not use any cleaning agents or brushes.
Cleaning the filter will remove the dirt, but will not restore the original color of the filter. The color
of the filter is not of any influence to the performance.
5. Press a much water as possible out of the cyclone filter and let it air dry completely for at least 24
hours.
Attention: using a damp cyclone filter could cause damage to the engine.
6. Press the cyclone filter back in the lid of the dust collector.
7. Close the lid of the dust collector. You will hear a click when it is closed correctly.
8. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed correctly.
USE
.
.
MAINTENANCE
EN - 16
4
19
17
18
20
Publicité
