Publicité
Les langues disponibles
Les langues disponibles
CAUTION: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent
electric shock.
Step 1. Remove the 1 of 3 screws from the posts
of the mounting ring and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2. Place the key holes in the mounting plate
over the two screws previously loosened from the
mounting ring. Turn the mounting plate until the
decorative cover locks in place at the narrow
section of the key holes. (Fig. 16)
Step 3. Securely tighten the two mounting screws
previously loosened and the one previously
removed.
Step 4. Position the notches in the outer rim of the
mounting plate so they line up with the tabs on the
decorative cover. Carefully lift the decorative cover
up inside the mounting plate and secure it to the
fan by turning the decorative cover clockwise until
snug. DO NOT OVERTIGHTEN.
Mounting
plate
Tab
Figure 16
Installing the Decorative Cover 10.
Installing the battery
Install a 12V MN21/A23 battery (included) into the
remote control. To prevent damage to the remote
control, remove the battery if not used for long
periods. (Fig. 17)
Mounting
ring
Screws
Decorative
cover
Figure 17
Publicité
