Siemens TI907F Serie Mode D'emploi page 49

Milk froth or warm milk
The appliance is switched on. The water
tank has been filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Select "Milk froth" or "Warm milk"
2.
with the rotary selector.
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink
~ "Adjusting beverage settings"
on page 50
To begin dispensing the drink, press
4.
the rotary selector.
Milk froth or warm milk is dispensed
into the cup or glass.
To prematurely stop dispensing
Note:
the drink, press the rotary selector
again.
Operating the appliance en
Dispensing hot water
Before dispensing hot water,
Note:
clean the milk system and remove the
milk container. If the milk system is not
cleaned, the dispensed water may
contain small quantities of milk.
~ "Cleaning the milk system"
on page 60
:
Warning
Risk of burns!
The outlet system becomes very hot.
After use, always let the outlet system
cool down before you touch it.
The appliance is switched on. The water
tank has been filled.
Place a cup under the outlet system.
1.
Remove the milk container, if
2.
connected.
Select "Hot water" with the rotary
3.
selector.
To change the settings for the
4.
selected drink
~ "Adjusting beverage settings"
on page 50
To begin dispensing the drink, press
5.
the rotary selector.
Hot water is dispensed into the cup.
To prematurely stop dispensing
Note:
the drink, press the rotary selector
again.
49