Hitachi Koki NV 38AB2 Mode D'emploi page 6

English
CAUTION:
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a
work bench on floor. Also, never face the nail outlet
toward any part of a person.
HOW TO USE THE NAILER
CAUTIONS:
Never use the head or body of this devise as a
hammer.
Take precautions to ensure the safety of persons in
the vicinity during operation.
NOTE:
Since nails are not driven if not attaching the nose
cap, make sure to use this nailer with the nose cap.
1. Nailing procedures
(1) Method of intermittently driving nails (single shot)
The single-contact change lever is in the single shot
position (See Fig. 8)
This nailer includes a single shot structure to allow
striking of a single nail by pushing down the push
lever and pulling the trigger (see Fig. 7).
CAUTION:
If you do not pull the trigger quickly and crisply while
in the single shot mode, the nailer will bounce and
shoot several nails instead of just one. To avoid this,
be sure to pull the trigger quickly and crisply.
At first, push the
push lever
against the
surface of the
material to be
nailed.
Single
Shot Position
Single-Contact
Change Lever
Push lever
When depressing the nail outlet, be sure to fully lift
the push lever (see Fig. 7) to release the safety lock.
Thus, nails cannot be driven without releasing the
safety lock even though the trigger is pulled.
(2) Method for continuous driving of nails (contact drive)
The single-contact change lever is in the contact
driving position (See Fig. 10).
5
Pull the trigger
Fig. 7
Fig. 8
First pull back the trigger. Then press the nail outlet
on the place to drive nails. Driving of nails will start.
(Fig. 9)
Use the accessory hexagon bar wrench to turn the
single-contact change lever to the contact driving
position. With the trigger pulled back, press the nail
outlet on the place to drive nails.
Continuous nail driving will start (See Fig. 10).
Press the
nail outlet
Contact
Driving Position
CAUTION:
Exercise care when nailing corners of lumber. When
continuous nailing corners of lumber, a nail may go
astray or break through the corner.
NOTES:
Precautions on no-load operation
Sometimes nailing will continue after driving in all
nails previously contained in the magazine.
This is termed "no-load operation". Such operation
may deteriorate the damper, magazine, and nail
feeder.
To avoid no-load operation, occasionally confirm the
amount of remaining nails. On the other hand, all
nails should be removed after using this nailer.
After completing operation, put into the body about
2cc oil through the hose joint to protect the tool from
rust.
Under low temperature conditions, the machine
sometimes does not operate correctly. Always operate
the machine at the appropriate ambient temperature.
2. Adjusting the nail-driving depth
(1) Adjusting the adjuster (Fig. 11)
CAUTIONS:
When making adjustments, be sure remove your
finger from the trigger.
Previously
Pull the Trigger
Fig. 9
Single-Contact
Change Lever
Fig. 10