Hitachi Koki NV 38AB2 Mode D'emploi page 5

Adjust the oiler so that a single drop of oil is supplied
at intervals of 5 to 10 nailing cycles.
(2) It is recommended using the recommended oil (SHELL
TONNA). Other applicable oils are listed. Never mix
two or more types of different oils.
3. Load nails
(1) Load nails in the magazine
Press the stopper and open the cover.
Load the nails in the magazine. Insert the beginning
of the nail into the opening of the magazine to facilitate
the following procedures (Fig. 1).
Magazine Opening
First section of the Nails
Cover
Close the cover after confirming that the nails are
loaded in the magazine.
(2) Load nails in the guide.
Greip the nail guide and knob with fingers. Then
depress the knob to open the nail guide towards the
left. (See Fig. 2)
Knob
Nail Guide
Extend the nail line from the magazine.
When using sheet collated nails
While pressing the linking sheet to the guide surface,
insert the first nail in the row of nails into the nail
outlet. Then insert the second nail between feeder 1
and feeder 2. Confirm at this time that the nail head
and the upper side linking sheet enter the guiding
groove (see Fig. 3, 4).
Nail
Fig. 1
Magazine Opening
First section
of the Nails
Fig. 2
Main Nail
Stopper
Sub Nail
Stopper
Nail Guide
Feeder 1
Nail Outlet
Nail Head
Main Nail
Stopper
Sub Nail Stopper
Nail Guide
When using wire collated nails
Insert the first nail into the nail outlet and the second
nail between the two pawls of feeders 1 and 2 so
that the nail head engages the guide slot. (Fig. 5 and 6)
First Nail
Nail Guide
Feeder 1
English
First Nail
Guide Slot
Linking
Sheet
Guide Surface
Feeder 2
Fig. 3
Guide Slot
Upper side
linking sheet
Fig. 4
Guide Slot
Feeder 2
Guide Surface
Fig. 5
Wire
Fig. 6
4