Programming Your Remote Control; Programming On A Somfy Rts Remote-Controlled Lamp Holder Or Socket - SOMFY Situo 1 RTS Manuel D'installation Et D'utilisation

PROGRAMMING YOUR REMOTE CONTROL

3.1 Programming on a Somfy RTS remote-controlled lamp holder or socket

▶ Programming a remote control
1. Check that the remote-controlled lamp holder/socket is switched on.
During this operation, disconnect all other lamp holders and sockets for Somfy remote-controlled devices in your
home.
2. Press the channel selection button as many times as necessary until the indicator lights show the channel to
be programmed.
3.
Press the programming button on the remote-controlled lamp holder/socket until the indicator light flashes.
4.
Use a fine-tipped object to make a short press on the PROG button on the back of the remote control.
The indicator light on the remote-controlled lamp holder/socket will come on permanently, then go off.
2
Examples of Somfy RTS remote-controlled lamp holders and sockets
3
EN - Installation and operating guide SOMFY RTS 1-channel – 5-channel remote controls
4
3
5