Sony UP-880 Mode D'emploi page 16

16
ad qzyer: eide) ats
On the safety
* Check the operating voltage before operation.
Operate the unit only with a power source specified in "Specifications".
* Stop operation immediately if any liquid or solid object falls into the cabinet.
Unplug the unit and have it checked by qualified personnel.
¢ Unplug the unit from a wall outlet if you will not be using it for a long time.
Disconnect the power cord by grasping the plug. Never pull the cord itself.
¢ Do not disassemble the cabinet. Refer servicing to qualified personnel only.
* Do not touch the cutting blade of the printer.
* Keep fingers clear of paper lid assembly and paper cutting blade when paper lid
is closing.
¢ Connect the power plug of the printer to a wall outlet having protective earth
terminal. The safety earth should be properly established.
On operation
Do not turn the power off while the printer is printing. The thermal head may be
damaged.
On printer carriage
Do not carry and move the printer when the paper roll is placed in the printer.
Doing so may cause malfunction.
On installation
¢ Place the printer on a level and stable surface during operation.
* Do not install the printer near heat sources. Avoid locations near radiators or air
ducts, or place subject to direct sunlight or excessive dust, humidity, mechanical
shock or vibration.
* Provide adequate air circulation to prevent heat build-up. Do not place the printer
on surfaces such as rugs, blankets, etc., or near materials such as curtains and
draperies.
Others