Télécharger Imprimer la page

Blomberg WAF 1320 A Mode D'emploi page 19

Publicité

Les langues disponibles

Les langues disponibles

Quick instructions for daily use
Preparation
1. Open water tap fully. Check if hoses
are firmly attached.
2. Place laundry in the drum.
3. Fill in detergent and fabric condition-
er.
Starting
1. Press the »On/Off« button.
2. Set the programme selector.
3. If desired:
– activate any additional function(s),
– set the spin speed,
– set the time delay.
4. Close the loading door.
5. Press the »Start/Pause« button.
The display shows the time remaining
for the programme to complete.
6. Check if the »Door« indicator lamp
has gone off (if not, see "Trouble-
shooting") .
Aborting a programme
• Press and hold the »Start/Pause« for
approx. 3 seconds.
The machine may pump out any wa-
ter still in the drum or goes through a
rinse cycle to cool off the laundry.
Adding more laundry
3
This is possible only:
– during a time delay,
– at the beginning of a washing cycle
(the appliance allows adding laun-
dry at a later stage only when the
water level is low or the temperature
is low).
1. Press the »Start/Pause« button.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press the »Start/Pause« button.
Programme is in rinse and hold
3
You can see this from the blinking of
the »Rinse hold« indicator lamp and
the »Start/Pause« button.
If you now want to spin:
1. Set spin speed.
2. Press the »Start/Pause« button.
The programme continues, pumps out
the water and spins.
If you want to pump out the water:
1. Set spin speed selector to »No spin«.
2. Press the »Start/Pause« button.
The programme continues and only
pumps out the water.
Re-spinning the laundry
3
The automatic spin-correction-system
can prevent spinning in case the drum
is out-of-balance.
If you wish to spin again:
1. Rearrange the laundry evenly in the
drum.
2. Set programme selector to »Spin«.
3. Set spin speed.
4. Press the »Start/Pause« button.
After the programme cycle is
completed
3
When the display shows the original
programme length again, the pro-
gramme is over.
1. If the »Door« indicator lamp is on,
open the loading door and remove
your laundry.
2. Press »On/Off« button.
3. Turn the water tap off.
4. Wipe out the fold in the rubber seal on
the door and check for foreign ob-
jects.
5. Leave door and detergent dispensing
drawer open to dry.
17
G

Publicité

loading