Publicité
Les langues disponibles
Les langues disponibles
Installation
Check the appendix for a compatible phone.
Before Installing the Telephone
1. Insert the plug on the long end of the handset cable into the jack
telephone and press the cable into the groove provided for it.
2. Insert the plug on the short end of the handset cable into the jack on the handset.
3. Write your telephone number and those for the fire and police departments
on the included label and attach it to the telephone housing underneath the
handset (see arrow).
4. Before using the telephone, remove the protective covering from the Nav-
igator/TouchGuide ring surface.
Installation at Place of Use
Notes about Place of Use
•
Operation of a SIP/HFA phone is only permitted with indoor LAN cabling (SELV network ac-
cording to IEC 60950-1). The device shall be connected to the IP infrastructure using a
shielded Cat 5 LAN cable. The LAN cabeling of the building shall ensure that the shield of
this cable is grounded.
•
The telephone should be operated in a controlled environment with an ambient temperature
between 5 °C and 40 °C (41 °F and 104 °F).
•
Do not install the telephone in a room where large quantities of dust accumulate; this can
considerably reduce the service life of the telephone.
•
Do not expose the telephone to direct sunlight or any other source of heat, as this is liable
to damage the electronic equipment and the plastic casing.
•
Do not operate the telephone in damp environments such as bathrooms.
Installing the Cables at the SIP/HFA Phone
1. Insert the LAN cable into the jack
2. If your LAN does not have PoE (Power over Ethernet; ask your service personnel), then you
need to use a power supply.
Insert the power supply plug into the jack
To prevent damage to the unit, it is imperative that you observe the following:
The power supply may only be plugged into the
3. If present, connect the KeyModule to the jack
The unit is now ready for operation.
If further settings are required for correct operation of the telephone, contact your service per-
sonnel.
Installing the Cables at the TDM Phone
1. Insert the U
cable into the jack
P0/E
2. If present, connect the KeyModule to the jack
The unit is now ready for operation.
If further settings are required for correct operation of the telephone, contact your service per-
sonnel.
[1] OpenStag 15 only
[1]
on the base of the telephone.
on the base of the telephone.
jack.
on the base of the telephone.
on the base of the telephone.
on the base of the telephone
Installation
on the base of the
1
.
5
Publicité
