Melitta Solo & Milk E953-102 Mode D'emploi page 26

Cleaning and maintenance
■ Insert the drip tray without the coffee
grounds container
■ Place the coffee grounds container
under outlet 2.
Cleaning phase 1 (
Two rinsing processes will be executed.
When illuminates, proceed as follows:
■ Remove the brewing unit.
■ Put a cleaning tab in the brewing unit
(Image C).
■ Insert the brewing unit.
Cleaning phase 2 (
When illuminates, proceed as follows:
■ Fill the water tank with tap water up to
the max. mark.
■ Press the
the cleaning programme (takes about
5 minutes).
Cleaning phase 3 (
When illuminates, proceed as follows:
■ Empty the drip tray and coffee grounds
container.
■ Insert the drip tray without the coffee
grounds container
■ Place the coffee grounds container
under outlet 2.
Cleaning phase 4 (
bean is fl ashing):
■ The cleaning programme will be
continued again and takes about
5 minutes.
When illuminates, proceed as follows:
■ Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is fi nished.
26
):
):
button to continue with
):
, the middle
Operating Instructions: Melitta
Integrated descaling programme
WARNING
The descaling agent can cause skin
irritations!
▶ Comply with the safety instructions
and the dosing information specifi ed
on the descaling agent packaging.
The integrated descaling programme
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling fl ashes during the entire
process.
The descaling programme should be
performed every 3 months, however, at
the latest when illuminates
("Setting the water hardness", page 24).
Only use Melitta ANTI CALC.
®
■ Switch off the device.
■ Pull the supplied hose approx. 1 cm over
the steam pipe (Image J) to prevent the
spraying of liquids.
■ Place the coffee grounds container to
the right of the appliance. The hose
should protrude into the coffee grounds
container as shown in Image J.
■ Remove the water fi lter if necessary
("Water hardness and fi lter", page 23).
■ Press the
and
simultaneously for approx. 3 seconds.
fl ashes, illuminates.
Descaling phase 1 (
■ Empty and reinsert the drip tray.
illuminates.
■ Completely empty the water tank.
■ Add the descaling agent to the water
tank according to the instructions on the
packaging.
■ Insert the water tank.
■ Press the
button to start the
descaling programme (takes about
15 minutes).
Solo & Milk | 1829-0618 | 2018-08
® ®
buttons
):