Melitta Solo & Milk E953-102 Mode D'emploi page 24

Water hardness and fi lter
Melitta PRO AQUA Filter cartridge
®
The Melitta PRO AQUA fi lter cartridge
®
fi lters lime scale and other contaminants
from the water. The water fi lter should be
changed every 2 months, however, at the
latest when
The water fi lter is available in specialised
shops.
Inserting the water fi lter
fl ashes during the entire change
procedure.
■ Put the water fi lter in a glass with
tap water for several minutes before
inserting it in the appliance.
■ Switch off the device.
■ Press and hold the
for approx. 3 seconds, then release.
appears on the display.
■ Empty the drip tray and insert without
the coffee grounds container.
illuminates.
■ Pull the water tank 7 up and out of the
appliance.
■ Empty the water tank.
■ Screw the water fi lter onto the thread at
the bottom of the water tank.
■ Fill the water tank with fresh tap water
up to the max. mark.
■ Insert the water tank into the appliance.
illuminates.
■ Place the coffee grounds container
under the steam pipe 12.
■ Turn the valve switch 11 clockwise
until it stops.
Water will fl ow into the vessel.
■ When
is illuminated on the display,
turn the valve switch 11 anticlockwise
until it stops.
24
appears on the display.
and buttons
fl ashes on the display.
Operating Instructions: Melitta
■ The device is ready for operation.
and illuminate. The water hardness
is automatically set to hardness level 1.
■ Empty and insert the coffee grounds
container.
After inserting the water fi lter, the water
can be cloudy during the fi rst rinse
because excess activated carbon is
washed out of the fi lter. The water will then
be clear again.
Setting the water hardness
The appliance includes a test strip to
determine the water hardness.
■ Determine the hardness of the tap water
using the test strip.
■ Switch on the device.
■ Press the
and
simultaneously for longer than
2 seconds. fl ashes rapidly.
■ Press the
button to show the
menu for setting the water hardness.
illuminates.
■ Set the determined water hardness by
pressing the button. The selected
water hardness is shown by the bean
symbols .
Water hardness
1:
2:
3:
4: fl ashing
■ Press
to confi rm the selection.
Solo & Milk | 1829-0618 | 2018-08
® ®
buttons
°dH °e °fH
0 - 1 0 0 - 1 3 0 - 1 8
10 - 1 5 13 - 1 9 18-27
15 - 2 0 19 - 2 5 27-36
> 20 > 25 > 36