Melitta Solo & Milk E953-102 Mode D'emploi page 21

Before using for the fi rst time
General information
■ Only use pure water without
carbonation.
■ Use the supplied test strip to determine
the hardness of the water used and set
the water hardness ("Water hardness
and fi lter", page 23).
■ If you wish to use a water fi lter, do not
insert it until after the initial startup.
Information for using for the fi rst
time
The appliance must be vented before it
is used for the fi rst time. The appliance
may only be powered on with a completely
fi lled water tank.
■ Place a vessel under the steam pipe 12.
■ Press the
button to switch on the
appliance. illuminates on the display.
■ Turn the valve switch 11 clockwise
until it stops. fl ashes on the display.
Water will fl ow into the vessel.
■ When
is illuminated on the display,
turn the valve switch 11 anticlockwise
until it stops.
■ The device is ready for operation.
■ After initial startup, insert the Melitta
PRO AQUA fi lter cartridge, if necessary
(see page 24).
Operating Instructions: Melitta
Starting up the appliance
Commissioning
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable!
▶ Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Image A, 13).
▶ Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
▶ Never use damaged power cables
(damaged insulation, bare wires).
■ Place the appliance on a stable, dry and
level surface with suffi cient clearance
(at least 10 cm) to the sides.
■ Plug the power cable into a suitable
power socket.
■ Remove the lid from the
bean container 8.
■ Fill the bean container with suitable
®
coffee beans.
■ Put the lid back on.
■ Lift up the lid of the water tank 7 and
pull the water tank up and out of the
appliance.
■ Fill the water tank with fresh tap water
only up to the max. mark.
■ Insert the water tank into the appliance.
■ Place a vessel under outlet 2.
■ Press the on/off
appliance on or off. The appliance may
perform an automatic rinse.
Solo & Milk | 1829-0618 | 2018-08
® ®
Before using for the fi rst time
WARNING
button to turn the
21