ISE SY-T2702 Instructions D'assemblage Et D'utilisation page 22

RUNNING BELT ADJUSTMENT METHOD
1.When running belt lean to the left, adjusting screw on the left 1-2 turns along the clock-
wise. Then, test running; If still lean to the left, repeat the above steps until back to the
center.
2.When running belt lean to the right, adjusting screw on the right 1-2 turns along the
clockwise. Then, test running; If still lean to the right, repeat the above steps until back to
the center.
3.When the running belt too tight, it will cause stronger resistance. Please adjust both
sides screws 1-2 turns along the counterclockwise, loosen the belt until stopping skid ding
or pausing; When the running belt too loose, please adjust both sides screws 1-2 turns
along the clockwise.
USE THE TREADMILL LUBRICANT
Location is in the middle of the lower surface of the running belt. When add lubricant,
please inject to the center of running board, then put down the belt, pressing the hole by
hands, rotating the belt to apply evenly.
Please be assured that the box of this product is recycling, the rest of the packaging can be trashed.
In case the product contains batteries, do not trash directly.
This device concerned has been manufactured under an EU
Declaration of Conformity and compliance with all relevant EU
Directives, including CE test and EN ISO 20957-1, EN 957-6.
Importer:
SAS ISE
1 Chemin d'Armancourt
60200 Compiègne France
TEL : +33 3 44 76 21 66
PORT : +33 6 32 91 85 26
contact@isefit.com
www.isefit.com
10
EN