ISE SY-T2702 Instructions D'assemblage Et D'utilisation page 15

Attention: Make sure all screws and nuts are tightened before Exercise
Step 1: Extending the framework
1.Both men take the treadmill out of the box and lay it flat on the ground.
2.Slowly stand up from the direction of the arrow. As shown in the figure below
Step 2. Assembly mode
1.The column is connected to the base: The left and right columns and the base holes are
assembled in the screw bag as shown in the figure below. A.M8 * 40 and C. flat pads are
respectively tightened in the tool kit M5 wrench.
INSTALLATION GUIDE
3
EN