Energetics POWER RUN 5.0 Mode D'emploi page 9

Care and Maintenance
The home exerciser should not be used or stored in a moist area because of possible corrosion.
-
Check at least every 4 weeks that all connecting elements are tightly fitted and in good condition.
-
In case of repair please ask your dealer for advice.
-
Replace defective components immediately and/or keep the equipment out of use until repair.
-
Only use original spare parts for repair.
-
After exercising, immediately wipe off the sweat; perspiration can ruin the appearance and proper
-
function of the Home Exerciser.
Use a damp cloth to clean the Home Exerciser. Never use abrasives or solvents to clean the Home
-
Exerciser. To prevent damage to the computer, keep liquids away and keep it out of direct sunlight.
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
-
BELT ADJUSTMENT:
Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has
been adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons
could cause the belt to shift off center resulting in the belt rubbing with the plastic side rail or end caps and
possibly causing damage. To adjust the belt back to it's proper position please follow the directions below:
Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the
•
hex key provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the
power cord back into the surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the
belt start to correct itself, moving back towards the center. Repeat the above procedure until the
walking belt is centered. It may be necessary to set walking belt tension once you have completed this
procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"
instructions.
Walking belt has shifted to the right: First unplug the power cord from the surge protector. Using the
•
hex key provided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the
power cord back into the surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the
belt start to correct itself, moving back towards the center. Repeat the above procedure until the
walking belt is centered. It may be necessary to set walking belt tension once you have completed this
procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"
instructions.
Walking belt is slipping: First unplug the power cord from the surge protector. Using the hex key
•
provided, turn both the left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in
the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 4
km/h (2.5 mph). You should now walk on the belt to determine if the belt is still slipping. Repeat the
above procedure until the walking belt is not slipping. The tension should be just tight enough not to
slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Right and left tension bolts are located at the rear of the treadmill.
9