Belkin F5D5141uk5 Manuel D'utilisation page 15

Information
EMI Certification
FCC Class B Certification (USA)
Warning: This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause interference to radio communications.
It has been tested and found to comply with the limits for a Class
B digital device pursuant to Subpart B of Part 15 of FCC Rules,
which are designed to provide reasonable protection against such
interference when operated in a commercial environment. Operation
of this equipment in a residential area is likely to cause interference,
in which case the user, at his or her own expense, will be required to
take whatever measures are required to correct the interference. Use
unshielded twisted-pair (UTP) cabling for RJ45 connections; Category
3 cabling or greater for 10Mbps connections; Category 5 cabling
for 100Mbps connections; and Category 5, 5e, or 6 for 1000Mbps
connections.
Canada Department of Communications – Class B
This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus as set out in the interference-
causing equipment standard entitled "Digital Apparatus," ICES-003 of
the Department of Communications.
CE Mark Declaration of Conformance for EMI and Safety (EEC)
This information technology equipment complies with the
requirements of the Council Directive 89/336/EEC on the
Approximation of the laws of the Member States relating to
Electromagnetic Compatibility and 73/23/EEC for electrical equipment
used within certain voltage limits and the Amendment Directive 93/68/
EEC. For the evaluation of the compliance with these Directives, the
following standards were applied:
RFI Emission:
• Limit class B according to EN 55022:1998
• Limit class A for harmonic current emission according to
EN 61000-3-2/1995
• Limitation of voltage fluctuation and flicker in low-voltage supply
system according to EN 61000-3-3/1995
13
1
2
3
4
5
6
7
8