1.5
CUSTOMER SERVICE AND REPAIR
In the event of a permanent fault which inter-
feres with operation, the appliance must be
switched off and disconnected from the
power supply.
To perform maintenance and repairs contact
the factory, the factory representative or a
local service company.
Repair, maintenance work and other adjust-
ments are only to be carried out by an
authorised specialist. The valid local and
national regulations must be observed. This
applies especially to burners, ignition, safety
and
control
elements.
replacement are only to be replaced by origi-
nal spare parts. Periodic tests for gas leaks
must be carried out. A service contract is
therefore recommended.
Cleaning and maintenance must be done
only when the heating surfaces are cold. Do
not use inflammable liquids to clean the
appliance.
An obligatory service check is required
annually.
Page 4
GENERAL INFORMATION
Parts
requiring
Get other manuals https://www.bkmanuals.com
2.
TECHNICAL DATA
PNC
Appliance type
Appliances
9CHG584105
WGGRAFQOOO
9CHG584106
WGGRAAQOOO
9CHG584107
WGGRABQOOO
9CHG584108
WGGWDFQQOO
9CHG584110
WGGWDAQQOO
9CHG584112
WGGWDBQQOO
9CHG584109
WGGWAFQQOO
9CHG584111
WGGWAAQQOO
9CHG584113
WGGWABQQOO
3.
GAS CONSUMPTION
Power
BTU
7.6
25900
20
68200
40
136500
47.6
163000
4.
PACKAGING
All the packaging materials used are environmentally friendly.
They may burnt at an incineration plant or recycled.
5.
TESTS / CERTIFICATES
All gas appliances are tested according to the standards
ANSI/NSF 4 - 2002 of Commercial Cooking, Rethermalization,
and Powered Hot Food Holding and Transport Equipment and
ANSI Z83.11-2002 and CSA 1.8-2002 of Gas Food Service
Equipment.
6.
SPECIFICATION PLATE
The specification plate (E) is located in each case inside and
outside on the right of the operator panel (C) (page 6 Fig. 5).
outside on the right of the operator panel (C) (page 6 Fig. 5).
The serial number is marked on the type plate. The 8 digits
give following information:
Y
last digit of the year of production
WW
week of production
XXXXX
running number
Width
Cooking
Depth
zones
Burner
oven
Height
inch
mm
Power in kW
19.7
500
35.4
900
2
20
35.4
900
39.4
1000
35.4
900
4
40
35.4
900
62.9540.01_UL
Gas
7.6