LEGRAND KEOR HPE 200 kVA Manuel De Fonctionnement page 200

UPS user manual
Manuel de l'utilisateur de l'ASI
Utilizzo dell'UPS
5.4.2 Setting the display language
The following picture shows the languages that can be set.
Picture 26 – Language setting
The language selection is made pressing one of the flags.
5.4.3 Setting the RS485 user interface parameters
The parameters regarding the communication via RS485 interface can be set in the MODBUS
RS485 section.
This section allows to set the ModBus address, the communication mode and the data
transmission speed.
5.4.4 Setting the display network parameters
The NETWORK CONFIG section allows to configure the parameters related to the LAN network
and to the system time synchronization server.
All the parameters that can be set in this section are related to the communication port (LAN)
available on-board the touch screen.
Picture 27 – Touch screen network parameters setting
OMP06263 REV. D 39