Parkside PWS 20 A1 Traduction Des Instructions D'origine page 22

GB IE
If foam or liquid exits, switch off the
machine immediately.
Carpet cleaning
For carpet cleaning, only use the
washer nozzle with the attachment
for hard surfaces (24) or the wash-
er nozzle for cleaning upholstery
(23).
1. Place the foam filter (11) onto the filter
basket (4a).
To prevent the foam filter (11) from tear-
ing,
- Only insert dry filters;
- Before inserting, twist the edge
of the filter slightly and then roll it
back.
2. Fill the water tank (
water (max. 3 l). Pay attention to the
markings on the container (
3. Pull (do not push!) the nozzle
( 23/24) in rows over the carpet/
upholstery.
Overlap the rows a bit to ensure thor-
ough cleaning.
4. Press the lever for the spray function
( 15a) on the handle part to turn on
the spray function.
5. Empty the container (7) immediately
after vacuuming, as it is not designed
to store liquids (see "Cleaning/Mainte-
nance").
In case of excessive dirt or stains,
add a bit of cleaning agent to the
water tank (not included in deliv-
ery).
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
22
19) with fresh
19).
General Cleaning Work
Never hose the appliance
down with water. Never use
aggressive cleaning agents
or solvents. This could dam-
age the appliance.
• Remove the water tank (
empty the container (
• Clean the container (
damp cloth.
• Wash the foam filter (11) with warm
water and soap and let it dry.
• Rinse the water channels (
with fresh water.
• Replace the paper filter bag (
when full (see "Replacement parts/Ac-
cessories" for reordering).
• After finishing the cleaning work, re-
install the motor head (
water tank (
• Always check the appliance before
use for any obvious faults such as a
defective mains cable, and have these
repaired or replaced.
Maintenance
The device is maintenance free.
Storage
1. Wind the mains connection cable (9)
around the retaining bracket on the
back of the appliance.
2. Wind the vacuum hose (16) around the
motor head (4).
3. The accessory holders (8a) on the cas-
tors (8) are used to store the suction
pipes and the smaller accessories.
4. Store the appliance in a dry place (rec-
ommended ambient temperature 15 -
30 °C) and out of reach of children.
19) and
7) after use.
7) with a
13+17)
12)
4) and the
19).