Parkside PWS 20 A1 Traduction Des Instructions D'origine page 17

General description
The illustration of the principal
functioning parts can be found
on the front and back foldout
pages.
Extent of the delivery
Carefully unpack the appliance and check
that it is complete.
The appliance is supplied with the motor
head fitted (
4). To remove the motor
head, open the sealing clips (
Dispose of the packaging material cor-
rectly.
4 Motor head
7 Container
8 4 castors with accessory holders
11 Foam filter
12 Paper filter bag
14 Suction pipe (2 parts)
16 Suction hose
20 Floor nozzle
21 Crevice nozzle
22 Upholstery nozzle
23 Washer nozzle for cleaning up-
holstery
24 Washer nozzle with attachment
for hard surfaces
25 Phillips screw
- Instruction Manual
Overview
Housing
1 Carrying handle (not visible)
2 On/Off switch
3 Pump switch
4 Motor head with filter basket
(4a)
5 Water duct connector
6 Fastening clip
10 Suction connector
11 Foam filter for wet suction
12 Paper filter bag to vacuum
13 Water duct at the suction pipe
6). 13a Release
14 Suction pipe
15 Handle with air regulation
16 Suction hose
17 Water duct at the suction hose
18 Notch
19 Water tank
19a Water tank lid
20 Floor nozzle
21 Crevice nozzle
22 Upholstery nozzle
23 Washer nozzle for cleaning up-
24 Washer nozzle with attachment
25 Phillips screw
Description of operation
The carpet cleaner is equipped with a sta-
ble stainless steel container for collecting
dirt and a separate water container for the
washer function. The castors provide good
manoeuvrability of the appliance. The suc-
tion flow is switched off by a float during
wet vacuuming once the waste tank is full.
The following describes the function of the
operating parts.
7 Container
8 4 castors with accessory holders
(8a)
9 Mains connection cable
Filters
coarse dirt
Accessories
Nozzles
holstery
for hard surfaces
GB IE
17